DIN Mounting Phase Angle Controllers

The 500 series of modules are designed for panel mounting. They are ideal for multi-feeder applications and can be connected so that they are electrically interlocking i.e. a unit can be wired so that when it stops it will automatically inhibit others. Sensor modules for level and track control are also available in this series.

Type 506 phase-angle controller for vibratory feeders rated for 2 Amps.

...............................................................................................................

The REOVIB 506 is designed for controlling bowl or linear feeders up to 2A current rating. The output frequency 50Hz/100Hz (60Hz/120Hz) is selected to suit the feeder. In the regulation circuit there is built-in compensation for mains variations. The set-point for the feed rate is derived from a potentiometer and the set-point range can be linearised by using two trimmers Umin/Umax. Furthermore, an enable input is provided for start/stop operation. Fixings are provided for rail mounting to DIN EN 50022-35.

Type 509 phase-angle controller for vibratory feeders rated for 15 Amps.

...............................................................................................................

The REOVIB 509 is designed for controlling bowl or linear feeders up to 15 A current rating. The output frequency 50Hz/100Hz (60Hz/120Hz) is selected to suit the feeder. In the regulation circuit there is built-in compensation for mains variations. The set-point for the feed rate can be derived from a potentiometer, a voltage signal 0...+10 VDC or a current signal 0...20 mA. The set-point range can be linearised by using two trimmers Umin/Umax. Furthermore, an enable input is provided for start/stop operation and there is a control input for use with a track control module (REOVIB 513). Fixings are provided for rail mounting to DIN EN 50022-35.

Type 513 sensor/timer module used for level or track control.

.............................................................................................................

The REOVIB 513 track control module is used for regulating the storage of product on a track. It can be used with nearly all proprietary types of sensors including active, through-beam and Namur types. A selector switch in the front-panel is used for choosing the sensor characteristics (PNP/NPN Output).
There are trimmers in the front-panel for adjusting the on/off switching time delays within a range of 0.5….15 secs. The sensor state (damped or not damped) and also the enable input (on/ff) state both have LED indicators. In addition a relay with changeover contacts, brought out to terminals, switches at the same time as the enable output.
Fixings are provided for rail mounting to DIN EN 50022-35.

Type 514 phase-angle controller for vibratory feeders rated for 6 Amps.

...............................................................................................................

The REOVIB 514 is designed for controlling bowl or linear feeders up to 6 A current rating. The output frequency 50Hz/100Hz (60Hz/120Hz) is selected to suit the feeder. In the regulation circuit there is built-in compensation for mains variations. The set-point for the feed rate can be derived from a potentiometer, a voltage signal 0...+10 VDC or a current signal 0...20 mA. The set-point range can be linearised by using two trimmers Umin/Umax. Furthermore, an enable input is provided for start/stop operation and there is a control input for use with a track control module (REOVIB 513). Fixings are provided for rail mounting to DIN EN 50022-35.